This web site requires Java Script.
You must enable Java Script on
your browser to navigate this site.
24-Chn Digital Input 4-Chn Analog Input
24 wide-range digital input channels with high voltage transient protection.
4 differential analog input channels with a ±10V common mode range and protection to ±40V.
Electrically isolated from the power supply rails, the communications bus, and the RS-232 / USB port.
Digital Inputs incorporate user programmable pull-up or pull-down resistors for use with either NPN or PNP sensors.
Digital Inputs respond to button presses and switch transitions using automatic debounce and typematic repeat with adjustable delay.
Logic state of each digital input channel can be read (or polled) by the host PC, or each channel can be set up to automatically report a logic transition without polling.
24 event counter inputs with 24-bits each and adjustable rollover limits.
12 quadrature encoder inputs with 24-bits each and adjustable rollover limits.
12 tachometer inputs which read the speed of a rotating shaft from 200 to 400,000 RPM.
Analog Inputs can read voltages from pressure transducers, load cells, strain gauges, temperature sensors, 4-20 mA devices, potentiometer positions, etc.
Analog Inputs incorporate 3 factory calibrated modes: +10.000 V to -8.000 V, ±600.0 mV, and ±600.00 mV.
Analog Inputs incorporate 2 user programmable modes which display readings in direct engineering units of choice.
Analog Inputs incorporate user programmable gain, offset, and decimal point position.
Analog Inputs use a 20-bit A/D converter which provides resolutions down to 1.4 µV (user programmable modes).
Software calibrated; no trim-pots to adjust.
All user configuration and calibration data stored in non-volatile memory.
Wide power supply range (10 to 30 VDC).
The WTX4 is a Data Acquisition and Control module which is available in various different versions that provide a wide assortment of input and output combinations. Multiple units can also be plugged together to create an expandable network. Each WTX4 unit is comprised of four individual sub units which can be a mix of Digital Inputs, Digital Outputs, Analog Inputs, Analog Outputs, and Thermocouple Inputs.
Our Data Collection Software is specifically designed to communicate with these DAQ modules and can be set up very quickly and easily by the novice using little or no programming skills. For more advanced programs with special requirements, our engineers can put together a custom software application for you. This can include the mapping of all of the data points to individual cells in your Excel Spreadsheet which will update automatically.