This web site requires Java Script.
You must enable Java Script on
your browser to navigate this site.
8-Chn Analog Input
8-Chn Digital Input 8-Chn Digital Output
8 differential analog input channels with a ▒10V common mode range and protection to ▒40V.
8 wide-range digital input channels with high voltage transient protection.
open-collector output channels with pull-ups to 5V for TTL level outputs. Electrically isolated from the power supply rails, the communications bus, and the
RS-232 / USB port. Analog Inputs can read voltages from pressure transducers, load cells, strain gauges, temperature sensors,
4-20 mA devices, potentiometer positions, etc. Analog Inputs incorporate 3 factory calibrated modes:
+10.000 V to -8.000 V, ▒600.0 mV, and ▒600.00 mV. Analog Inputs incorporate 2 user programmable modes which display readings in direct engineering units of choice.
Analog Inputs incorporate user programmable gain, offset, and decimal point position.
Analog Inputs use a
20-bit A/D converter which provides resolutions down to 1.4 ÁV (user programmable modes). Digital Inputs incorporate user programmable
pull-up or pull-down resistors for use with either NPN or PNP sensors. Digital Inputs respond to button presses and switch transitions using automatic debounce and typematic repeat with adjustable delay.
Logic state of each digital input channel can be read (or polled) by the host PC, or each channel can be set up to automatically report a logic transition without polling.
8 event counter inputs with
24-bits each and adjustable rollover limits. 4 quadrature encoder inputs with
24-bits each and adjustable rollover limits. 4 tachometer inputs which read the speed of a rotating shaft from 200 to 400,000 RPM.
Digital Outputs can directly control the on/off states of relays, solenoids, magnetic latches, flow valves, DC motors, etc.
Digital Outputs incorporate a clamping diode to protect it from
back-EMF generated by relay coils. Digital Outputs incorporate a resettable fuse which protects it from excessive current flow.
8 timer outputs that span from 1 mS to 65,535 mS each.
Re-loadable on the fly. 1 PWM
1-Amp output channels. Duty cycle adjustable using 0.1% increments. Software calibrated; no
trim-pots to adjust. All user configuration and calibration data stored in
non-volatile memory. Wide power supply range (10 to 30 VDC).
The WTX4 is a Data Acquisition and Control module which is available in various different versions that provide a wide assortment of input and output combinations. Multiple units can also be plugged together to create an expandable network. Each WTX4 unit is comprised of four individual sub units which can be a mix of Digital Inputs, Digital Outputs, Analog Inputs, Analog Outputs, and Thermocouple Inputs.
For other ordering options click here
Add to Cart